Description
-
Holds a set pressure in your fermenter or keg by automatically venting excess CO2
-
Diaphragm design is more accurate than spring and poppet spunding valves, especially at lower pressures
-
Ideal for pressure fermentation and keg-to-keg, fermenter-to-keg and keg-to-bottle transfers
-
Includes a 0-15 PSI push-in gauge so you can monitor vessel pressure at a glance
-
Comes complete with a Duotight ball lock QD, ready to use right out of the box
BlowTie Spunding Valve Complete Kit
The BlowTie lets you set and hold the pressure inside a vessel while it vents. As your beer ferments or transfers, any CO2 above your set point is released, and the rest stays in the vessel. Use it to ferment under pressure, or to keep head pressure on the receiving keg during closed transfers so your beer holds its carbonation.
Why a Diaphragm Spunding Valve?
Traditional spring and poppet spunding valves have a gap between the pressure at which they open and the pressure at which they reseal. The BlowTie uses a diaphragm instead, so once excess gas is released, the pressure left in your vessel ends up much closer to the pressure you set. It is also more accurate at the low pressures used for most homebrew fermentations.
Setting Your Pressure
Turn the yellow knob on top of the BlowTie clockwise to raise the pressure setting and counterclockwise to lower it. To dial it in, start with a keg that is carbonated or pressurized to a known pressure (for example, 15 PSI). Attach the kit and turn the knob until gas begins to release at your target pressure (for example, 10 PSI).
Easy to Clean
The BlowTie is made from food-grade acetal with stainless steel screws, and it comes apart with a Phillips screwdriver for cleaning.
Kit Includes:
-
1 x BlowTie Diaphragm Spunding Valve
-
1 x Duotight 8 mm (5/16 in.) Female x 8 mm (5/16 in.) Female Tee
-
1 x 8 mm Push-In Pressure Gauge, 0-15 PSI
-
1 x Duotight 8 mm (5/16 in.) Ball Lock Disconnect, Gray/Gas
-
2 x 8 mm Rigid Plastic Joiners
Specifications:
-
Pressure range: 0-15 PSI
-
Connections: 8 mm (5/16 in.) Duotight push-in on inlet and outlet
-
Body material: food-grade acetal
-
Screws: stainless steel
Please note: The rigid joiners are semi-permanent once pushed in and are difficult to remove. If you want a setup you can fully take apart, use short pieces of 8 mm OD EVABarrier tubing in place of the joiners.
WARNING: Do not exceed the gauge's 15 PSI rating. Exceeding the pressure range will damage the gauge.
KegLand Part Number: KL09706